The Prospect of Using Joinery in Commercial Applications

When selecting joinery for commercial applications, there are a few crucial factors to consider. The right material will provide optimal joint stability and longevity, which makes it essential. And the finishing of the joinery will impart a finished look.

Of course, wood is the most common choice. This material is well known for its strength and its ability to absorb moisture and protect the joints. However, in commercial applications where moisture tends to be abundant, more common options include metal or plastic materials.

Wood is famous for its beauty and durability, but it may not provide the support needed for some joining tasks. There is as well a wide range of grain patterns available that can alter the pattern of the joinery and improve the quality of the final product.

Also, wood has many drawbacks. It is susceptible to warping in particular locations, which can result in joints that are not as strong as they should be. Warping can also occur when the temperature changes and the wood expands and contracts during the curing process. It can cause significant stresses.

Wood is also not an ideal material for those who intend to paint or stain the pieces in their interiors. Since wood cannot be polished, stains and paints tend to have little effect on the grain pattern of the wood. Paint can create swirls and patterns that are not present in the wood.

But it is not just the finish that matters. For wood, a matte finish is best, and it can help prevent accidental chipping of the wood in rough working conditions. Also, hardwood requires a longer time to cure than softwood.

To help ensure a smooth surface, but allow for the natural surface irregularities, porcelain or acrylics may be used to enhance the quality of the wood. But in most cases, it is best to choose a substance that is readily available at a local hardware store.

Some materials used for Commercial Joinery in Adelaide are poplar, redwood, cedar, and pine. The wood types may vary depending on the project and the assembly requirements. In general, the same basic process must be followed regardless of the wood type.

The planks are cut to size and pre-drilled. After the edge of the wood is shaped, mortise and tenon joinery are accomplished by wedging the two wood edges together and clamping them in place. The mortise is tightened using an oscillating tool called a mortiser.

After this is done, the mortise is ground to shape and then glued to the cut piece of wood. Then, the entire piece is sanded to remove any remaining irregularities. Finally, the piece is stained to match the finish of the interior walls and floors.

A joinery material made from metal or plastic can be used for wooden components as well. However, the cost of all these materials is relatively low compared to wood. Also, metal or plastic costs less to produce and can be left unfinished, allowing the installation crew to finish them off when they are complete.

To ensure your commercial wood products are correctly installed, it is essential to follow the procedure outlined above. The results will be the best quality that you can obtain from Commercial Joinery in Adelaide.